L-3 Communications X200xp manual AC/DC Power Adapter, Power Cable, Video Cable

AC/DC Power Adapter

Connect the AC/DC Power Adapter to the X200xp Connector labeled “Power”, and to AC power (wall outlet). Connecting the AC/DC Power Adapter will disable the batteries, and the X200xp will receive its power from this outlet.

The AC/DC Power Adapter will provide power to the camera – however, it will not recharge batteries installed in the camera.

When the AC/DC Power Adapter is connected, the Battery Gauge will indicate “Empty”.

Power Cable

Connect the Power Cable to the X200xp Connector labeled “Power”, and to any 12volt DC Power Source. Operation of the X200xp will be the same as above (AC/DC power adapter).

The Power Source used by the customer should be capable of supplying at least 500ma.

The Power Source used by the customer should be nominal 12Vdc, however, can range from 8-16Vdc without harm to the camera.

Video Cable

Connect the Video Cable to the X200xp Connector labeled “Video”, and to a Video Monitor. When Connecting the Video Cable, the video will automatically switch from the internal LCD Display to the External Video Monitor, and visa versa.

3-4 seconds may be needed for the video to stabilize when switching between External Video Monitor and Internal LCD Display.

The X200xp Camera will not output External Video and Internal LCD Display Simultaneously.

18