LA Audio Electronic EQX20 In general lower Qs are used when boosting and higher Qs when cutting - see applications

1 20

Page 10

In general lower Qs are used when boosting and higher Qs when cutting -

FREQUENCY control

This control adjusts the centre frequency for LF cut or boost

The LF FREQUENCY control has a 40:1 range and is adjustable from

20Hz, CCW to 1kHz, CW. The following diagram shows the effect of

changing the centre frequency.

MF control

Sets the amount of cut or boost for the MF (Mid Frequency) section.

FREQUENCY control

This control varies the cut or boost centre frequency for the MF (mid

Frequency) section. Control range is 200Hz, CCW to 8kHz, CW.

Q control

Varies the 'Q' of the cut or boost region for the MF section.

HF control

Contents

Main Dual 3 Band, Mono 6 Band Param etri c Equali ser OPERATION MANUAL Page CONTENTS 1.0 INTRODUCTION 2.0 INSTALLATION Signals in excess of +20dB will cause the unit to distort. Plugging a mono jack lead into the TRS input will effectively un-balance the signal connection. 3.0 WARRANTY 4.0 DESCRIPTION OF CONTROLS Maximum cut or boost occurs at the centre frequency set by the FREQUENCY control. In general lower Qs are used when boosting and higher Qs when cutting - see applications Page Page 5.0 APPLICATIONS