La Crosse Technology TX7U instruction manual Inventory of Contents, Setting UP

TX7U Outdoor Temperature/Humidity Sensor

The TX7U outdoor temperature/humidity sensor can be added to your existing units in operation. The outdoor temperature/humidity sensor measures the outdoor temperature and humidity (or any other location you wish to know the temperature and humidity) and transmits the data to the indoor display station.

Outdoor temperature/humidity sensor

Mounting Bracket

INVENTORY OF CONTENTS

1.Outdoor temperature/humidity sensor.

2.Mounting bracket.

3.Rain protector.

4.Two each, ½” Philips mounting screws.

5.One strip double sided adhesive tape.

6.Instruction manual and warranty return card.

ADDITIONAL EQUIPMENT (not included)

1.One Philips screwdriver.

2.One Flat screwdriver.

3.Two fresh AA 1.5V batteries.

I. SETTING UP

Before you begin, assign a number to each outdoor temperature/humidity sensor (i.e. #1 for outdoors, #2 for the basement, etc.) if you have multiple sensors. This will help you determine which temperature, from which outdoor temperature/humidity sensor, you are reading on the indoor display station.

Note: Remove batteries from all existing units in operation—including outdoor temperature/humidity sensor units and indoor display stations. When setting up multiple units it is important to insert batteries first into all the outdoor temperature/humidity sensors, and in numeric sequence. Second install batteries into the indoor display station. Transmission problems will arise if this is not done correctly and if the total time for setup exceeds 6 minutes.

A.BATTERY INSTALLATION

Follow these directions when first setting up, when replacing batteries, or for resetting purposes.

1.Remove the batteries from all existing display units in operation.

2.Using a screwdriver, unscrew and open the battery cover located at the front of the outdoor temperature/humidity sensor.

Battery	Battery cover
compartment