La Crosse Technology WS-6118 Function Keys, Atomic Clock Lcd Screen Descriptions, Manual Settings

Alkaline batteries are recommended for use in both units. Avoid using rechargable batteries.

NOTE: Do not set the clock until the outdoor temperature is displayed.

1.Place batteries in the outdoor transmitter first, then into the atomic clock. DO NOT PRESS ANY BUTTONS FOR 10 MINUTES.

2.After the 10 minutes both the Indoor and Outdoor areas on your clock should have a temperature showing. If not, remove both sets of batteries, wait 10 minutes and repeat step one.

3.After the clock receives the outdoor temperature the WWVB time code reception will automatically start. This reception typically takes between 5-10 minutes in good conditions. If after 10 minutes the WWVB time has not been received, use the “SET” key to manually enter the set-up mode and change either the time or date in order to activate the WWVB reception (see manual settings below). The clock will then automatically attempt to receive the WWVB time from 12:00 am through 6:00 am each day (attempts WWVB reception every full hour within this time frame). When this is successful, the received time will override the manually set time. The date is also updated with the received time (Please refer to notes on “Radio controlled time” and “Manual time setting”).

4.After the time signal has been received or the search mode has been manually stopped the indoor temperature will be displayed.

Note:

In the event of changing batteries of the unit ensure that the batteries do not spring free from the contacts. Always wait at least 10 minutes after removing the batteries before reinserting, otherwise start up and transmission problems may occur.

FUNCTION KEYS

The atomic clock has four easy to use keys:

SET key	: To enter into the set mode for the following functions: time zone, DST ON/OFF
	(daylight saving time), language, hour, minute, year, month, day, weekday, 12/24
	hour, ºC or ºF temperature display
+ key	: To toggle between the second, temperature or weekday display
	To change any values in manual set mode
ALM key	: To enter into the alarm set mode
	To set the alarm ON/OFF

SNZE key	: To activate the snooze function during alarm
	To display the alarm time in normal mode display
	To exit the setting modes

ATOMIC CLOCK LCD SCREEN DESCRIPTIONS

The atomic clock's LCD is divided into 2 sections and once the batteries are inserted, all the segments will light up briefly before displaying the information for time, date, indoor and outdoor temperatures.

Radio reception icon

WWVB time	Alarm icon
Indoor temperature	Outdoor temperature display
Date	Weekday

MANUAL SETTINGS

Note:

If the atomic clock has already successfully received the WWVB time signal and displays the correct time and date, then the Manual settings can be skipped.

After completion of the above described procedures in “Setting up” the manual setting modes can be entered by pressing and holding the SET key for 3 seconds. The following settings can now be programmed:

•Time zone setting

•DST ON/OFF

•Language display setting

•Manual time setting

•Year setting