La Crosse Technology WS-8054U instruction manual Temperature Alarm, Function Buttons, Program Mode

B) TEMPERATURE ALARM

1)Remove the battery cover, located on the backside of the unit.

2)Observe the correct polarity and install 2 AA batteries.

3)Replace the battery cover.

+S I Z E A A

S I Z E A A +

GB P.10

WWVB Radio reception

		TIME		Alarm
WWVB
		ALARM
Time		SNOOZE		Icon
Date			Outdoor
			temperature
Weekday or		Indoor temperature
seconds display	or seconds display

The temperature alarm will conduct a WWVB search every hour until the first signal is found. Once the WWVB time is found, a search is automatically conducted nightly at midnight. If the signal is found at midnight, the tower icon will remain, if not, another search will take place every hour (until 6:00 am) until the signal is found successfully. If no signal is found during this period, the

GB P.12

I) FUNCTION BUTTONS

There are 3 function buttons located on the front of the temperature alarm and one on the top. The function buttons are labeled:"SET", "+", "ALARM", and "SNOOZE" (the top bar).

	R A D I O C O N T R O L L E D
		TIME	SET
			+
			ALARM
DATE	INDOOR	OUTDOOR

Note: After the batteries have been installed a tone will sound, and all the LCD's (Liquid Crystal Display) will briefly light up. The indoor temperature, the date as "1/ 1", the weekday as "MON", and the remote temperature will be displayed (within three minutes). Also, the time will appear as "-:--" for approximately 1 minute. TheWWVB search is automatically initiated, and a tower icon appears and flashes with the time colon (no tower icon will appear if the WWVB is too weak to be detected, and the time display will remain on "-:--"). While the WWVB search is being conducted various numbers will appear in the time display. After 10minutes, the temperature alarm will either display the WWVB time, or discontinue the search if the time is not found. If the search is cancelled "-:--" will appear in the time LCD.

P.11 GB

tower icon will not appear and the clock will search again at 12:00 am the next night.

PROGRAM MODE

To enter the program mode hold down the "SET" button for 2 seconds, until "-5EST" flashes in the date LCD. The program mode is laid out in a manner that allows you to program each function separately, or you can follow the instructions entirely to program the temperature alarm. Complete programming is usually done for the initial set-up, and will require you to skip step 1 of programming sections III through VIII. Press the "SNOOZE" button at any time to exit the program mode, or wait approximately 15 seconds for the temperature alarm to automatically return to normal operation.

P.13 GB

II) TIME ZONE SETTING

1)Hold down the "SET" button for 2 seconds, the default setting "-5EST" will flash in the date LCD.

2)Press and release the "+" button to select the appropriate time zone. There are 13 time zones to choose from:

-4ATL	Atlantic Time
-5EST	Eastern Time (default setting)
-6CST	Central Time
-7MST	Mountain Time
-8PST	Pacific Time
-9ALA	Alaskan Time
-10HAW	Hawaiian Time
-11, -12	Next tow time zones West of HAW
GMT	Greenwich Mean Time
-1, -2, -3GMT	Three time zone West of GMT

GB P.14 P.15 GB