LaCie LaCie 319 LCD Monitor, Troubleshooting, User’s Manual, page, Image is unstable or

LaCie 319 LCD Monitor			4. Troubleshooting
User’s Manual			page 22
	The Problem	Possible Solutions
	Image is unstable or	• Signal cable should be completely attached to the computer.
	unfocused	• Use the OSM Image Adjust controls to focus and adjust display by increasing or decreasing
		the fine total. When the
		display mode is changed, the OSM Image Adjust settings may need to be readjusted.
		• Check the monitor and your display card with respect to compatibility and recommended sig-
		nal timings.
		• If your text is garbled, change the video mode to non-interlace and use 60Hz refresh rate.
		• Please be aware that LCD Technology may experience a phenomenon known as Image
		Persistence. Image persistence occurs when a residual or “ghost” image of a previous image
		remains visible on the screen. Unlike CRT monitors, LCD monitors’ image persistence is not per-
		manent, but constant images being displayed for a long period of time should be avoided. To
		alleviate image persistence, turn off the monitor for as long as the previous image was
		displayed. For example, if an image was on the monitor for one hour and a residual image
		remains, the monitor should be turned off for one hour to erase the image. NOTE: As with all
		personal display devices, LaCIe recommends displaying moving imagesand using a moving
		screen saver at regular intervals whenever the screen is idle or turning off the monitor when not
		in use.
	LED on monitor is not lit • Power Switch should be in the ON position and power cord should be connected.
	(no green or amber color
	can be seen)
	Display image is not	• Use the OSM Image Adjust controls to increase or decrease the Coarse total.
	sized properly	• Check to make sure that a supported mode has been selected on the display card or system
		being used.
		(Please consult display card or system manual to change graphics mode.)
	No Video	• If no video is present on the screen, turn the Power button off and on again.
		• Make certain the computer is not in a power-saving mode (touch the keyboard or mouse).
	No Tilt	• Rotate the screen to 90° clockwise until you hear one click.
		• Refer to the Quick Start section, “Remove monitor stand for mounting” to insure correct
		installation of stand.