Installation
1.Connect the Ethernet cable to the product and to your local network (network hub, switch, or router).
2.Connect the power supply.
3.Push the power button until the front LED blinks blue. Release the button and the product will boot, which may take up to two minutes. When the light becomes steady blue, the product is ready to use.
4.Install and run LaCie Network Assistant, located on the
Router or Hub
OUT 
IN
Fig. 1
Fig. 2
Fig. 3
Note: If you want to turn off the drive, press and hold the power button for 5 seconds until the LED blinks blue. When the LED turns off, the drive has shut down.
