How To Change or Clean Washable HEPA Filter and Final Filter (Model 6999 only)
Final Filter
(underneath
side)
Open filter cover by lifting up on | Clean or replace washable HEPA |
latches and pulling filter cover out | filter. Clean or replace final filter in |
and away from the cleaner. | filter cover and close cover. |
Use GENUINE EUREKA washable HEPA filter, 61053. To clean filter rinse dirty side of filter under warm, low pressure water being careful not to get the clean side wet (this increases drying time). Do not put damp filter back in vacuum cleaner. Allow to thoroughly air dry.
Ensure the filter cover is securely fastened.
Use GENUINE EUREKA Final filter, 61262. The final filter can be cleaned. Run under water and allow to thoroughly air dry.
How to Replace Worn Belt or Light Bulb
NOTE: Disconnect power cord and wands from electrical hose before replacing belt or bulb. Belt pulleys can become hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt.
4. Return brush roll into base.
1.Remove two screws from bottom side. To turn over, grasp hood near handle socket and lift forward.
Replace headlight bulb, if necessary. Support socket with one hand and push light bulb into socket; turn to release. Place new light bulb into socket; turn to secure. Push light bulb and socket back so bulb will not touch lens cover. Use GENUINE EUREKA replacement bulb, 59224.
Continue to step 2 to change belt. Skip to step 7 and 8 to replace hood on motorized nozzle.
{
Brush
Roll
Pulley
5.Rotate belt onto motor pulley.
6.Replace brush roll cover.
2.Remove two screws located in front of the light bulb and lift up to remove the brush roll cover.
Motor Shaft
{
3. Lift out brush roll; replace new belt around brush roll shaft.
