Masterbuilt 20070910 HOW to USE Wood Chip Loader, Assembly Instructions, Adding more wood during

HOW TO USE WOOD CHIP LOADER

			Before starting unit, place 1 cup of
			wood chips in chip loader.
			Never use more than 1 cup of
			wood chips at a time.
			Insert wood chip loader into smoker.
			Wood chips should be level with top
			rim of wood chip loader.
			Turn handle to “Unload” mark on
			smoker. Wood will drop onto wood
			chip holder. Turn handle to “Load”
			and leave wood chip loader in place
			inside smoker.
			Check wood chip holder periodically
			to see if wood has burned down by
			removing wood chip loader and
			looking into smoker through hole.
			Add more chips as needed.
			Wood chip loader must be pulled out
			completely from smoker when
Load			checking wood chip level.
Unload			Adding more wood during
			smoking process:
			Caution: Keep smoker door closed
			when adding wood chips.
			Note: Wood chip loader will be HOT
			even if handle is not.
			To add wood, turn handle to “Load”
			mark on smoker.
			Pull wood chip loader from smoker.
			Place wood chips in wood chip
		Load	loader and re-insert into smoker.
			Turn handle to “Unload” mark on
			smoker. Wood will drop onto wood
	Unload		chip holder.
			Temperature may spike briefly after
			wood is added. It will stabilize after
			a short time. Do not adjust.

CAUTION

When door is opened a flare up may occur. Should wood chips flare up, immediately close door, wait for wood chips to burn down then open door again. Do not spray with water.

ASSEMBLY INSTRUCTIONS Continued

Step 3

Mount control panel by inserting stabilizing screw head into keyhole as shown.

stabilizing screw

Note: Stabilizing screw may need slight adjustment for snug fit.

keyhole

Step 4

Secure control panel to smoker with

(2) m5X.08x10 panhead screws provided.

Note: Do not over tighten.

6

9