Land Pride
Shredder Assembly Instructions
Replacing Blade Spacers
Refer to Figure 5:
The cutting blades should not have more than 3/4" free vertical movement at the blade tips. If vertical movement exceeds 3/4", install or change to thicker spacers (#3) following steps 1 through 5.
Order spacers (#3) and locknuts (#7) from your nearest Land Pride Dealer.
IMPORTANT: Read “Safety Information” on page 1 before disassembling the shredder blades.
IMPORTANT: Locknuts can lose their ability to lock properly once removed. Always use a plain throw away nut during
IMPORTANT: Spacers (#3) are not required if vertical movement at blade tip is 3/4" or less without spacers. However, spacers are required if vertical movement at blade tip is greater than 3/4".
25600
1.Check blade deflection. If vertical deflection at the blade tip is greater than 3/4", remove blade bolt (#6) and reassemble using thicker spacers (#3). Select spacer thickness based on deflection. The greater the deflection, the thicker the spacer.
2.Assemble blades by inserting
Draw nut up snug. Do not tighten.
3.Check blade deflection. If deflection at the blade tips are greater than 3/4", remove blade bolt and reassemble as before except use thicker spacers.
4.Once blade deflection is correct, replace plain nut with supplied locknut (#7) & torque to 450
5.Repeat instructions for “Replacing Blade Spacers” for the remaining shredder blade assemblies.
Blade
Cutting
Edge
Position Beveled
Edges Down
CCW
Rotation
Blade
Cutting
Edge
CW
Rotation
Blade Cutting Edges
Position Beveled Edges Up
(#1) Right Wing Shredder Assembly | (#2) Center Deck & Left Wing Shredder Assemblies |
Clockwise Rotation | Counterclockwise Rotation |
| Figure 5 |
8/20/07 ■ | Manual No. | 5 |
