Land Pride
Instructions For Kit No
Refer to Figure 8:
14.Crimp Butt Connector with crimping part of wire strippers to secure connector place.
Crimp Portion of |
|
the Wire Strippers | Butt |
| Connector |
| Main Wire |
| harness |
24594
Crimping Butt connector
Figure 8
Refer to Figure 9:
15.Plug the new splice wire spade terminals into the terminal slots where the purple ground wires were removed.
New Splice Wire |
Terminal Ends |
Bare Wire End |
23817 |
Plug Splice Wire Into Connector
Figure 9
Refer to Figure 10:
16.Insert bare wire end of new splice wire into splice connector as shown.
17.Locate orange wire leading into main wiring harness and attach splice connector over orange wire as shown.
IMPORTANT: Force metal prong down with pliers before closing splice connector cover. Forcing prong down with cover will damage the splice connector.
18.Make certain bare wire end is fully inserted into the splice connector and then force metal prong down into the connector with pliers.
19.Close splice connector cover. Make certain it snaps shut.
20.(Optional) Press Butt Connector against main wire harness and secure in place with electrical tape.
Butt |
Connector |
Main Wiring
Harness
Orange |
Wire |
Splice
Connector
Bare Wire
End of New
Splice Wire
Splice | Metal | |
Prong | ||
Connector | ||
cover |
|
23818
Figure Description
Figure 10
Refer to Figure 11:
21.Reattach main wiring harness to mower frame with new plastic ties.
22.Check battery drain as outlined in step 5 before reconnecting battery ground wire. Amp reading should not exceed .001 milliamps.
23.Reconnect battery ground wire to negative post
Negative
Ground Wire
Negative Post ( - )
21127
Figure Description
Figure 11
24.Lower seat deck and start mower to verify it will start. Shut mower off and lock seat down to complete installation.
1/16/07 ■ | Manual No. | 3 |
