Land Pride
Instructions For Kit No 356-142A
Refer to Figure 3:
6.Locate main wiring harness attached to the mower frame. Cut plastic ties securing harness in place.
Mower Frame
Plastic Tie |
Main Wiring
Harness
23813
Locate Wire Harness
Figure 3
Refer to Figure 4:
7.Pull white connector out from under back right corner of mower frame.
8.Unplug connector by pressing down on the center tab and pulling the two ends apart.
Female End
Press Here to
Unplug Connector
Male End
23814
Unplug Connector
Figure 4
Refer to Figure 5 & Figure 6:
9.Locate two purple ground wires leading from the connector to the main wiring harness.
Backside of
Connector
Main Wiring
Harness
Purple Wire
23815
Remove Purple Ground Wires
Figure 5
10.Insert terminal removal tool or small thin bladed screw driver into backside (see Figure 5) of a purple wire connector slot. Push in on the purple wire and press down on the holding tab. See Figure 6 below for view of holding tab. Once the tab has released, pull purple ground wire out. If the terminal does not release, reposition terminal tool and pull on the wire again.
Spade Terminal Holding Tab |
24595 |
Spade Terminal Holding Tab
Figure 6
11.Repeat step 10 to remove second purple ground wire.
Refer to Figure 7:
12.Cut both purple wires close to the spade terminals. Cutting close will leave enough wire to install butt connector in step 13 below.
Spade
Terminals
Cut Close to Spade Terminals
Wire Cutters
23816
Cutting Spade Terminals Off
Figure 7
Refer to Figure 7:
13.Strip 3/8" length of outer covering from both ends of purple ground wires. Twist wire ends together and
Butt
Connector
Two Purple
Ground Wires
Main Wiring
Harness
23819
Installing Butt Connector
Figure 7
2 | Manual No. | ■ 1/16/07 |
