Land Pride
Shredder Assembly Instructions
Replacing Blade Spacers
Refer to Figure 4:
The cutting blades should not have more than 3/4" free vertical movement at the blade tips. If vertical movement exceeds 3/4", install or change to thicker spacers (#1) following steps
Order spacers (#1) and locknuts (#8) from your nearest Land Pride Dealer.
IMPORTANT: Read “Safety Information” on page 1 before disassembling the shredder blades.
IMPORTANT: Locknuts can lose their ability to lock properly once removed. Always use a plain throw away nut during
IMPORTANT: Spacers (#1) are not used if vertical movement at the blade tip is 3/4" or less without spacers. However, spacers are required if vertical movement at the blade tips are greater than 3/4".
1.Check blade deflection. If vertical deflection at the blade tip is greater than 3/4", remove blade bolt (#4) and reassemble using a thicker spacer (#1). Select spacer thickness based on deflection. The greater the deflection, the thicker the spacer.
2.Assemble blades by inserting
3.Check blade vertical movement. If movement at the blade tip is greater than 3/4", remove blade bolt and reassemble as before except use a thicker spacer.
4.Once blade deflection is correct, replace plain nut with supplied locknut (#5) & torque to 450
5.Repeat instructions for “Replacing Blade Spacers” for the remaining shredder blade assemblies.
Position Beveled
Edges Down
Blade
Cutting
Edges
(#1) Right Wing Shredder Assembly | (#3) Left Wing Shredder Assembly | |
Clockwise Rotation | ||
Counterclockwise Rotation | ||
|
Lower Blade Cutting Edges
Position Beveled Edges Up
(#2) Center Deck & Shredder Assemblies
Counterclockwise Rotation
25603
Figure 4
8/20/07 ■ | Manual No. | 3 |