Land Pride FM3188 V-Belt Installation, Storage, Table of Contents, Maintenance and Lubrication

Land Pride Table of Contents

Section 4: Maintenance and Lubrication

FM3188 Cutting Knife Replacement

Refer to Figure 4-3:

The cutting knives have a cutting edge on both the leading and trailing edges. When the leading edge wears out, turn existing pair of knives around 180 degrees and reinstall. Replacement knives should be the same length as existing knives to maintain rotor balance.

1.Remove nylock nut (#1), bolt (#2) and spacers (#3).

2.Remove existing cutting knives (#4) or turn existing pair of knives around 180 degrees and reinstall.

3.Install cutting knife with existing bolt, spacers and nylock nut.

4.Tighten nylock nut to proper torque as listed in the "Torque Values Chart" on page 24.

3

1

2

4

24985

Fine Cutting Knives (FM3188 Only)

Figure 4-3

FM4188 Hammer Knife Replacement

Refer to Figure 4-4:

Replacement knives should be the same length as existing knives to maintain rotor balance.

1.Remove nylock nut (#1) and bolt (#2).

2.Remove old hammer knife (#3) and install new knife with existing bolt and nylock nut.

3.Tighten nylock nut to proper torque as listed in the "Torque Values Chart" on page 24.

2

1

3

24869

Hammer Knives (FM4188 Only)

Figure 4-4

V-Belt Installation

Refer to Figure 4-5:

!CAUTION

Belt drive system is under spring tension; use care to avoid bodily harm!

1.Remove belt guard fender (#1) and belt cover (#2).

2.Remove belt tension by loosening the belt tension bolt (#3) until belt can be removed.

3.Remove old belts from pulleys and install new belts.

4.Tighten belt tension bolt. See “Belt Tension Adjustment” on page 15.

5.Reinstall belt guard (#2) and belt guard fender (#1).

6.Tighten bolts to the proper torque. Refer to “Torque Values Chart for Common Bolt Sizes” Page 24.

3

2

1

24865

Belt Installation

Figure 4-5

Storage

Clean the Flail Mower at the end of the working season or when the mower will not be used for a long period.

1.Clean off any dirt or grease that may have accumulated on the mower and moving parts. Scrape off compacted dirt from under the hood and then wash the surface thoroughly with a garden hose. A coating of oil may also be applied to the area to minimize oxidation.

2.Check rotor knives and knife bolts for wear and replace if necessary. See “Rotor Knife Replacement” on page 16.

3.Inspect for loose, damaged or worn parts and adjust or replace as needed.

4.Lubricate as noted in the Lubrication portion of this section starting on page 18.

5.Store mower in a clean, dry place. The unit should be positioned on a flat surface with jack stands lowered to suitable 3-Point height. Ensure that the main frame is stable.

6.Repaint parts where paint is worn or scratched to prevent rust. Ask your dealer for Aerosol Land Pride touch-up paint #821-011C.

3/21/07 FM3188 & FM4188 Flail Mowers 309-523M 17