6

Section 1: Installation

PF10 & PF20 Pallet Forks 319-033M 1/28/08
Land Pride
Table of Contents
Installation
The PF10 and PF20 Pallet Forks are designed forSkid
Steer and TractorLoader buckets.
!WARNING
Light weight tractors and some skid steer loaderswill require
rear ballast for heavy loads to maintain steering control.
Be sureto consult your Tractor/Skid Steer Operator’s Manual
to determine whether or not to add ballast.
Two Pallet Fork Installation
Refer to Figure 1-1:
1. Openthroat of Pallet Forks by unscrewing swivel
pad (#2) with sliding clamp handle (#1).
2. Whenpossible, attach the Pallet Fork to a reinforced
section of the bucket8 1/2" or more right of center of
the bucket. If bucketis equipped with teeth, make
sure the Pallet Forkis positioned between the teeth.
3. Slidethroat of Pallet Fork onto the bucket floor until
front of bucket makescontact with back of throat.
4. Positionthe other PalletFork an equal distance left of
center of the front loader bucket and slide throat of
IMPORTANT: The throat opening is designed to
accommodate a variety of bucketsizes and does not
fit tight. Therefore, it is normal forthe Pallet Forks to
have some movement around the throat opening
when not under load.
PalletFork onto the bucket floor until the bucket front
makes contact with back of throat. If bucketis
equipped with teeth, makesure the unit is positioned
between the teeth when sliding it on.
5. SecurePallet Forks to the bucket by tightening
handles (#1) until swivelpad (#2) is tight against the
bucket floor.Do not overtighten.
Three Pallet Fork Installation
Refer to Figure 1-1:
1. Openthroat of Pallet Forks by unscrewing swivel
pad (#2) with sliding clamp handle (#1).
2. Centerone of the Pallet Forks in the middle of the
bucketand slide throat of Pallet Fork onto the bucket
floor until the bucketfront makes contact with back of
throat. If bucket is equipped with teeth, make sure
the unit is positioned between the teeth when sliding
it on.
3. Positionthe other two Pallet Forks an equal distance
(8 1/2" or more) left and right of center fork and slide
throat of Pallet Forks onto the bucketfloor until the
bucket front makescontact with back of throat. If
bucket is equipped with teeth, makesure the units
are positioned between the teeth when sliding them
on.
4. SecurePallet Forks to the bucket by tightening
sliding clamp handles (#1) until swivel pad (#2) is
tight against the bucket floor.Do not overtighten.
Section 1: Installation
Pallet Fork Installation
Figure 1-1
25761
Back of
Throat
1
2
Throat Opening