Lanier 480-0066 manual Material Safety Data Sheet

Models: 480-0066

1 3
Download 3 pages 26.11 Kb
Page 1
Image 1
MATERIAL SAFETY DATA SHEET

Lanier Worldwide, Inc.

2300 Parklake Dr., N. E.

Atlanta, GA 30345-2979

Emergency Telephone: (800) 526-4371

MATERIAL SAFETY DATA SHEET

Section 1: Chemical Product and Company Information

Identity:

5613 Toner

MSDS No.

CP- 345

Product ID:

480-0066

Issued:

09/20/01

 

 

Supersedes:

None

Synonyms

 

Date:

09/20/01

& Common

Toner for Lanier 5613

Prepared by:

EH&S Department 770-496-9500

Names:

 

Approved by:

Larry Choskey, Manager, CEH&S

 

Lanier 5613

European

Walter Fricke, Manager, Safety &

Uses:

 

Contact:

Environment,

 

 

 

Lanier Worldwide, Inc.

Chemical

Mixture

 

Im Taubental D -41468 Neuss,

Formula:

 

 

Germany +49-2131-387-177

Section 2: Composition / Information on Ingredients

 

PERCENT

CAS No.

EXPOSURE LIMITS

SOURCE

Polyester resin

50 - 80

0-00-0

8 mg/m3 10 mg/m3

N/a

Styrene acrylic polymer

10 – 40

25767-47-9

Not listed

N/a

Carbon black

< 15

1333-86-4

3.5 mg/m3 3.5 mg/m3

OSHA PEL ACGIH TWA

Dye

< 5

31714-55-3

Not listed

N/a

Carnauba wax

< 5

8015-86-9

Not listed

N/a

*PEL as the product: 15mg/m3 (total dust), 5mg/m3 (respirable dust)

*TLV as the product: 10mg/m3 (total dust), 5mg/m3 (respirable dust)

 

Section 3: Hazards Identification

HMIS Rating:

 

FLAMMABILITY = 1

HEALTH = 1

REACTIVITY = 0

SPECIAL = none

Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure to any non- toxic dust. May cause gasping if inhaled. Inhalation should be avoided. May cause temporary eye discomfort.

Health Hazards of Long Term exposure (Chronic): A manufacturer sponsored chronic inhalation study in rats using a special test toner revealed there were no lung changes at all in the lowest exposure level (1mg/m3), the most relevant level to potential human exposures. A very slight degree of fibrosis was noted in 25% of the animals at the middle exposure level (4mg/m3), while a slight degree of fibrosis was observed at the highest exposure level (16mg/m3) in all animals. These findings are attributed to “Lung Overloading”, a generic response to excessive amount of any dust retained in the lungs for a prolonged interval. The special test toner was ten times more respirable than commercially available toner to comply with EPA testing protocol and would not function properly in Xerographic equipment.

Carbon Black is listed on the IARC Monograph and the Massachusetts Substance List. The IARC has evaluated the evidence for the carcinogenicity of Carbon Black as inadequate to determine a carcinogenic risk for humans.

This product contains no known hazardous materials as defined by the OSHA Hazard Communication Standard 29 CFR 1910.1200.

Section 4: First Aid Measures

 

Remove to fresh air if effects occur. Get medical

 

In case of contact, immediately flush eyes with

Inhalation:

attention if needed.

Eye Contact:

water for 15 minutes. Get medical attention if

 

 

 

needed.

Skin Contact:

Wash with soap and water.

Ingestion:

Dilute stomach contents with several glasses

 

 

 

of water. Get medical attention.

Section 5: Fire Fighting Measures

Suitable extinguishing media: CO2, dry chemical, foam or water.

Extinguishing media which may not be used for safety reasons: none

This material will burn in case of fire. The decomposition products are CO, CO2, and Nox. Avoid inhalation of smoke. Special protective equipment for fire fighters: none

UEL: n/a

LEL: n/a

 

 

Page 1
Image 1
Lanier 480-0066 manual Material Safety Data Sheet