Lantronix 900-422 manual Autostart Automatic, Connection, Hostlist

Chapter 9: Setup Mode: Channel Configuration

			If a partial IP address is presented in a command string, it is
			interpreted to be the least significant bytes of the IP address and
			uses the internally stored remote IP address to provide the most
			significant bytes of the IP address. If the IP address entered is
			0.0.0.0/0, the device server enters Monitor Mode.
			For example, if the remote IP address already configured in the
			unit is 129.1.2.3, then an example command string would be
			C3/7. (This would connect to 129.1.2.3 and port 7.) You may
			also use a different ending for the connection string. For
			example, C50.1/23 would connect you to 129.1.50.1 and port 23.
	Figure 9-2. Manual Connection Address Example
	Command String	Result if remote IP is 129.1.2.3 and remote port is 1234
	C121.2.4.5/1	Complete override; connection is started with host 121.2.4.5, port 1
	C5	Connects to 129.1.2.5, port 1234
	C28.10/12	Connects to 129.1.28.10, port 12
	C0.0.0.0/0	Enters Monitor Mode
Autostart (Automatic			If you enable Autostart, the unit automatically connects to the
Connection)			remote IP address and remote port specified when the firmware
			starts.
Hostlist			If you enable this option, the device server scrolls through the
			hostlist until it connects to a device listed in the hostlist table.
			Once it connects, the unit stops trying to connect to any others. If
			this connection fails, the unit continues to scroll through the table
			until it is able to connect to another IP in the hostlist.
			Hostlist supports a minimum of 1 and a maximum of 12 entries.
			Each entry contains the IP address and the port number.
			The hostlist is disabled for Manual and Modem Modes. The unit
			does not accept a data connection from a remote device when
			the hostlist option is enabled.

XPress DR+ User Guide 74