8: Monitor Mode
WiBox2100E User Guide 35
Monitor Mode CommandsThe following commands are available in Monitor Mode.
Note: All commands must be in capital letters.
Table 8-1. Monitor Mode Commands
Command Command Name Function
VS Version Queries software header record (16 bytes) of unit.
GC Get Configuration Gets configuration of unit as hex records (120
bytes).
SC Send Configuration Sets configuration of un it from hex records.
PI x.x.x.x Ping Pings unit with IP address x.x.x.x to check device
status.
AT ARP Table Shows the unit’s ARP table entries.
TT TCP Connection
Table
Shows all incoming and outgoing TCP connections.
NC Network Connection Shows the unit’s current IP address.
RS Reset Resets the unit.
QU Quit Exits diagnostics mode.
G0, G1, ....,Ge, Gf Get configuration
from memory page
Gets a memory page of configuration information
from the device.
S0, S1,...,Se, Sf Set configuration to
memory page
Sets a memory page of configuration information
on the device.
GM Get MAC address Shows the unit's 6-byte MAC.
SS Set Security record Sets the Security record without the encryption key
and length parameters. The entire record must still
be written, but the encryption-specific bytes do not
need to be provided (they can be null since they
are not overwritten).
SA Scan Initiates a wireless scan. Reports any stations
found, including BSSID, SSID, and RSSI.
If SA is followed by a string, that string is used to
filter SSIDs before reporting.
Note: If the BSS does not broadcast its SSID, only
the BSSID and RSSI are returned.
NS Network Status Reports the status of the network interfaces,
including negotiated parameters like speed/duplex
for Ethernet or BSSID, encryption, and
authentication for wireless interfaces.