WiSpan User Guide 34
8
8:
:M
Mo
on
ni
it
to
or
rM
Mo
od
de
e
Monitor Mode is a command-line interface used for diagnostic purposes. There are two
ways to enter Monitor Mode: locally by means of the setup port or remotely by means of
the wired network.
Entering Monitor Mode via the Setup Port
To enter Monitor Mode locally:
1. Follow the same steps used for setting the serial configuration parameters.
(See 4: Quick Start.)
2. Instead of typing three x keys, however:
a) Type zzz to enter Monitor Mode with network connections.
b) Type yyy to enter Monitor Mode without network connections.
A0> prompt indicates that you have successfully entered Monitor Mode.
Entering Monitor Mode via the Network Port
To enter Monitor Mode using a Telnet connection:
1. Establish a Telnet session to the configuration port (9999). The following message
displays:
** Lantronix WiSpan Device Server ***
MAC address 00204A89468C
Software version V6.5.0.2T4 <070221>
Press Enter for Setup Mode
2. Type M (upper case).
A0> prompt indicates that you have successfully entered Monitor Mode.