BASE ASSEMBLY
Locate Hardware Bag “A” to Assemble Base. (Figure 1)
1.Place Base on floor.
2.Fit Mounting Flange through large hole in center of Base.
3.Insert (4)
4.Tilt Base and secure one Carriage Bolt at a time by first putting on a 3/8” Split Lockwasher and then a
5.GO BACK AND FULLY TIGHTEN each Hex Nut so that the Flange is securely assembled to the Base.
6.Thread the 3/8-16 X 1” Square Head Bolt into the Mounting Flange.
Carriage Bolts (4)
Square Head
Bolt
Mounting Flange
Base
Split Lockwasher (4) | Hex Nut (4) |
|
Figure 1
WHEELS TO BASE ASSEMBLY
Locate Hardware Bag “D” to Assemble Wheels to Base. (Figures 2 and 3)
1. Remove Wheel Assemblies from Hardware Bag “D”.
2. Take note that Wheel Assemblies are RIGHT and LEFT handed. (Figure 3)
3.Place one Wheel Assembly on Base location as shown.
4.Align two bolt holes and insert 5/16 - 18 X 1” Long Carriage Bolt. (Figure 2)
5.Tilt Base and Secure one bolt at a time by first put- ting on a 5/16 Split Lockwasher and then a
6.Repeat steps 2 thru 5 with other Wheel Assembly.
Figure 2
CORRECT | INCORRECT |
Figure 3
Rev. E 8/10 | 3 | 5084445 |