MODEL 5355
GENERAL SAFETY INFORMATION
When using electrical appliances, basic precautions should always
be followed to reduce the risk of fire, electric shock and injury to persons,
including the following:
1.Read all instructions before using this Heater.
2.Use this Heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electrical shock, or injury to persons.
3.Make certain that the power source conforms to the electrical requirements of the Heater.
4.Extreme caution is necessary when any Heater is used by or near children or invalids and whenever the Heater is left operating unattended.
5.This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
6.DO NOT plug Heater into any other cord connected device, such as a power strip, surge protector, multiple outlet adapters or
7.Avoid the use of extension cords because the extension cord may overheat and cause a risk of fire. However, if you have to use an extension cord, minimize the risk of overheating by ensuring that they are UL listed. The cord shall be a
8.Do not operate any Heater with a damaged cord or plug or after the Heater malfunctions, has been dropped or damaged in any manner. Return Heater to authorized service facility for examination, electrical or mechanical adjustment or repair.
9.To disconnect Heater, turn controls to OFF, then remove plug from outlet.
10.Always unplug Heater when not in use. Unplug power cord before servicing or moving the Heater.
WARNING: DO NOT DEPEND ON THE ON/OFF SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER WHEN SERVICING OR MOVING THE HEATER. ALWAYS UNPLUG THE POWER CORD.
11.Do not insert or allow fingers or foreign objects to enter any ventilation or exhaust opening as it may cause an electric shock, fire, or damage the Heater. Do not block or tamper with the Heater in any manner while it is in operation.
12.To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not place on soft surfaces, like a bed, where openings may become blocked.
13.Always place the Heater on a stable, flat, level surface when operating, to avoid the chance of the Heater overturning. Locate the Power Cord so the Heater or other objects are not resting on it. Do not run Power Cord under carpeting. Do not cover Power Cord with throw rugs, runners, or the like. Arrange Power Cord away from room traffic and where it will not be tripped over.
14.This Heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Always use handle when moving this Heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9 m) from the front of the Heater and keep them at least 1 foot (0.3 m) from the sides and rear.
15.A Heater has hot and arcing or sparking parts inside. Do not use the Heater in areas where gasoline, paint, or flammable liquids are used or stored. It must NOT be used in potentially dangerous locations such as flammable, explosive, chemical- laden or wet atmospheres. This Heater is intended for general use ONLY.
16.This Heater is not intended for use in wet or damp locations. This Heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate a Heater where it may fall into a bathtub or other water container.
17.Do not use Heater outdoors.
WARNING: REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK – DO NOT USE THIS HEATER WITH ANY SOLID STATE SPEED CONTROL DEVICES.
MODELO 5355
FUNCIÓN DE SEGURIDAD
1.Se incorpora un protector para sobrecargas térmicas a fin de impedir el sobrecalentamiento.
2.Cuando se alcanza una temperatura de sobrecalentamiento, el Calefactor se apaga automáticamente. Sólo podrá reanudar su funcionamiento una vez que se reinicie la unidad. (Véase las instrucciones de reinicio más abajo).
Para Reiniciar el Calefactor:
1.Desenchufe el Calefactor y espere 10 minutos para que la unidad se enfríe.
2.Después de 10 minutos, enchufe el Calefactor nuevamente y siga la Instrucción de Funcionamiento que se describe en este manua l de instrucciones.
CONSEJOS PARA IDENTIFICAR PROBLEMAS
Si su calefactor se apaga inesperadamente o no funciona, es probable que la función de seguridad descrita anteriormente se haya activado para impedir el sobrecalentamiento.
1.Cerciórese de que el cable eléctrico esté enchufado en un tomacorriente en buen estado.
2.Revise su posición del Termostato. El Calefactor podría estar apagado porque alcanzó la temperatura deseada.
Si tiene algún problema que no pueda resolverse con los pasos indicados más arriba, contacte a Asistencia Técnica al
MANTENIMIENTO
A DV E RT E N C I A : S I E M P R E D E S C O N E C T E E L E N C H U F E A N T E S D E M OV E R O PROPORCIONAR SERVICIO.
ADVERTENCIA: ¡NO SUMERJA EL CALEFACTOR EN AGUA!
LIMPIEZA: ¡IMPORTANTE! Limpie la parrilla del Calefactor con un aditamento de cepillo en su aspiradora. Esto eliminará la suciedad y el polvo que se pueden acumular al interior del Calefactor. Limpie el cuerpo del calefactor con un paño suave.
NO INTENTE DESARMAR EL CALEFACTOR.
ADVERTENCIA: No use gasolina, bencina, acetona, limpiadores abrasivos, etc., puesto que eso dañará el Calefactor, NUNCA use ALCOHOL o SOLVENTES.
SERVICIO: Cualquier otro servicio, con la excepción de mantenimiento general por parte del usuario, deberá ser realizado por un representante de servicio autorizado. Llamar al
ALMACENAMIENTO: Guarde el Calefactor, con estas instrucciones, en su caja original en un lugar fresco y seco.
SAVE THESE INSTRUCTIONS
Rev. A 5/05 | 2 | 5355ES | Rev. A 5/05 | 11 | 5355ES |
