Digital Video Winder
for 6mm Mini DV Tapes
Model MDV66
Thank you for purchasing Lenmar’s model MDV66 Mini DV cassette
INSTRUCTIONS
1.Insert four “AAA” 1.5Volt batteries in the battery compartment as indicated by the diagram inside the battery compartment, or connect the optional AC Adapter to the rear power jack.
2.Open the lid by lifting from the handles located on either side. Insert the Mini DV cassette into the slot and push down on the lid to close.
3.Set the direction switch to Rewind or Fast Forward accordingly. Press the Start button in until it locks and the tape will begin winding in the direction you chose. While the unit is operating, the lid will be locked and cannot be opened until the unit has been stopped.
4.You may stop the unit at any time during operation by pressing the Stop button briefly and releasing. Otherwise, when the tape reaches the end, the unit will stop automatically. Once the unit has stopped the lid is unlocked and may be opened and the tape removed.
Warning: Do not change the direction switch while the unit is running as this may damage the tape. If you wish to change direction, first stop the unit, then change the direction switch and start the unit again.
Notes:
•The unit will not operate without a tape installed.
•If the AC adapter unit is being used, the power will be taken from the AC adapter in favor over the batteries (if installed).
•Use of alkaline batteries is recommended for best operation
•Use of AC adapter not designed for use with this unit may cause damage and void warranty.
SPECIFICATIONS:
Power: 4 x AAA 1.5V batteries (Optional – 110VAC Adapter)
Tapes: For use with 6mm Mini DV type tapes only
Drive: DC motor with belt drive
WARRANTY
Limited
