HEARTH PRODUCTS KITS AND ACCESSORIES
750,207M
REV. A 07/2007
DIRECT VENT CHASE TOP SQUARE VERTICAL TERMINATIONS
INSTALLATION INSTRUCTIONS FOR BLACK -
AND TERRA COTTA -
SV4.5CTS
Or SV8CTS
Termination
GENERAL INFORMATION
The SV4.5CTS and SV8CTS series terminations are designed to be installed on top of locally fabricated chimney enclosure, referred to herein as a chase. The terminations are designed to be used with tested and listed Direct Vent pipe systems and manufactured appliances listed for use with this product. The SV4.5CTS and SV8CTS terminations are additionally designed and painted to be suitable for use by itself without surround, providing a beautiful top to a standard chase.
Chase Flashing
(Field Fabricated)
Pipe
Section
KIT CONTENTS
1 - Termination
1 - Bag with fifteen (15) stainless steel screws
1 - Instruction Sheet
WARNINGS
This termination is intended to be installed in accordance with the installation guidelines of the pipe system and appliance it is joined to. Failure to install this product within those guidelines as well as these installation instructions can result in damage of property, bodily injury, or death. The installation must conform with local codes or, with the national fuel gas code, or ANSI Z223.1.
It is highly recommended that this product be installed by a qualified technician. It is highly recommended that the technician be NFI certified for gas appliance installations.
APPROVALS AND LISTINGS
The SV4.5CTS and SV8CTS series terminations are tested as a integral component of the Direct Vent pipe system and may be used with any manufactured fireplace listed for use with these components. These terminations are listed for this application by
FOR YOUR SAFETY
When working on ladders, roofs, scaffolding, or any high surface, take precautions to protect against accidents. Properly secure ladders, wear safety harnesses and verify all operations are done to OSHA standards. Also be aware of and avoid any and all electrical wires in or near your working area.
When working with and around sheet metal, be aware of material edges. Always wear gloves, safety glass and any other needed protective gear when working with sheet metal.
Take appropriate precautions when operating power equipment.
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.