UPFLOW FURNACE SIDE RETURN AIR
FIGURE 4
DOWNFLOW FURNACE
FILTERS IN PLENUM RACK
FIGURE 5
Blower
Check and clean blower wheel for any debris. Blower mo&
tor is prelubricated for extended bearing life. No further lu&
brication is needed.
WARNING
Blower door must be securely in place when blower and burners are operating. Gas fumes, which could contain carbon monoxide, can be drawn into living space resulting in personal injury or death.
Burner Flame
The G27M burner flame is not adjustable; however, the flame should be inspected at the beginning of each heat& ing season and burners should be cleaned, if necessary. Burner flame should be blue when burning natural gas.
BURNER FLAME
FLAME
FLAME APPEARS BLUE IF
BURNING NAT. GAS.
HEAT
EXCHANGER
TUBE
BURNER | VEST |
| |
| PANEL |
FIGURE 6
Venting System Inspection
Annually (before heating season) inspect furnace venting system, vent cap, heat exchanger and burners for corro& sion, deterioration, or deposits of debris. Remove any ob& structions.
Contact your Lennox dealer for a periodic unit inspection by a qualified service technician.
Flame Rollout Safety Switches
Your Lennox furnace is equipped with two flame
Service Reminder
Call your Lennox service technician if unit is inoperative. Before calling, always check the following to be sure ser& vice is required.
1 - Check that electrical disconnect switches are ON.
2 - Are access panels securely in place?
3 - Check room thermostat for proper setting.
4 - Replace any blown fuses or reset circuit breakers.
5 - Gas valve should be ON.
6 - Air filter should not be plugged limiting air flow.
7 - Is gas turned on at meter?
8 - Is manual main shut&off valve open?
To keep your Lennox gas heating system in peak op% erating condition year after year, contact your inde% pendent Lennox dealer about a planned service pro% gram.
Page 5