Installing memory
Your computer has either two or four connectors for installing dual inline memory modules (DIMMs). Some computers have two memory connectors that provide up to a maximum of 2.0 GB of system memory. Some computers have four memory connectors that provide up to a maximum of 4.0 GB of system memory.
vIf your computer has just two memory connectors, your system board has DDR type memory. DDR memory modules are
vIf your computer has four memory connectors, your system board has DDR2 type memory. DDR2 memory modules are
To install a memory module:
1.Remove the computer cover. See “Removing the cover” on page 10.
2.Access the system board. See “Accessing system board components” on page 12.
3.Remove any parts that might prevent access to the memory connectors.
4.Locate the memory connectors. See “Identifying parts on the system board” on page 13.
5.Open the retaining clips.
6.Position the memory module over the memory connector. Make sure that the notch 1 on the memory module aligns correctly with the connector key2 on the system board. Push the memory module straight down into the connector until the retaining clips close.
Chapter 1. Installing options 17
