Chapter 4. Completing the parts replacement
After replacing the parts, you need to close the cover and reconnect cables,
including telephone lines and power cords. Also, depending on the part that was
replaced, you might need to confirm the updated information in the Setup Utility
program. Refer to ″Using the Setup Utility program″ in the User Guide for this
product.
To complete the parts replacement:
1. Ensure that all components have been reassembled correctly and that no tools
or loose screws are left inside your computer. See “Locating components” on
page 8 for the location of various components.
2. Make sure that the cables are routed correctly before lowering the drive-bay
assembly.
Important
Correctly route all power supply cables to avoid interference with the
drive bay assembly. Keep cables clear of the hinges and sides of the
computer chassis.
3. Lower the drive-bay assembly and position the drive locks to the locked
position. Otherwise, you cannot close the computer cover.
4. Close the computer cover.
5. If a cover lock is installed, lock the cover.
6. Reconnect the external cables and power cords to the computer. See “Locating
connectors on the rear of your computer” on page 6.