Installing a drive in bay 2
To install an optical drive or an additional hard disk drive in bay 2:
1.Open the computer cover. See “Opening the cover” on page 12.
2.Remove the metal shield from the drive bay by using a
3.If you are installing a drive with accessible media, such as an optical drive, remove the plastic panel in the bezel by squeezing the plastic tabs that secure the panel on the inside of the bezel.
Note: If you are installing a
4.Slide the drive into the bay until it locks into position.
Figure 11. Installing a drive in bay 2
5.Pivot the drive bay assembly upward to gain access to the cable connections and connect the drive signal and power cables.
6.Continue at “Connecting a Serial ATA drive.”
Connecting a Serial ATA drive
A serial optical drive or an additional hard disk drive can be connected to any available SATA connector.
1.Locate the available SATA connector on the system board. See “Identifying parts on the system board” on page 9.
2.Using the signal cable that came with the new drive, connect one end of the signal cable to the drive and the other to the available SATA connector on the system board.
18ThinkCentre Hardware Installation and Replacement Guide