Chapter 4. Completing the parts replacement
After completing all parts replacements, you need to close the cover and reconnect cables, such as power cords. Depending on the parts replaced, you might need to confirm the updated information in the Setup Utility program. Refer to “Using the Setup Utility” in the ThinkCentre User Guide for this product.
To complete the parts replacement:
1.Ensure that all components have been reassembled correctly and that no tools or loose screws are left inside your computer. See “Locating components” on page 8 for the location of various components.
2.Make sure that the cables are routed correctly before lowering the drive bay assembly.
Important
Correctly route all power supply cables to avoid interference with the drive bay assembly. Keep cables clear of the hinges and sides of the computer chassis.
Figure 32. Cable routing
3.Lower the drive bay assembly and position the drive locks to the locked position. Otherwise, you cannot close the computer cover.
4.Close the computer cover.
5.If a cover lock is installed, lock the cover.
6.Reconnect the external cables and power cords to the computer. See “Locating connectors on the rear of your computer” on page 6.
7.To update your configuration, see “Using the Setup Utility” in the ThinkCentre User Guide.
© Copyright Lenovo 2008 | 35 |
