Lenovo manual Hibernation mode, Lenovo IdeaPad S110 Hardware Maintenance Manual

Lenovo IdeaPad S110 Hardware Maintenance Manual

•If a “suspend time” has been set on the timer, and the user does not do any operation with the keyboard, the hard disk, the parallel connector, or the dis- kette drive within that time.

•If the battery indicator is amber, indicating that the battery power is low. (Alter-

natively, if Hibernate when battery becomes low has been selected in the “Power Management Properties” window, the computer goes into hibernation mode.)

To cause the computer to return from sleep (standby) mode and resume the operation, do one of the following:

•Press the Fn key.

•Open the lid.

•Turn on the power switch.

Also, in the following event, the computer automatically returns from sleep (standby) mode and resumes the operation:

• The time set on the resume timer elapses.

Note: The computer does not accept any input immediately after it enters sleep (standby) mode. Wait a few seconds before taking any action to reenter operation mode.

Hibernation mode

In hibernation mode, the following occurs:

•The system status, RAM, VRAM, and setup data are stored on the hard disk.

•The system is powered off.

To cause the computer to enter hibernation mode, follow the steps below:

•If you are using the ACPI operating system and have defined one of the fol- lowing actions as the event that causes the system to go into hibernation mode, perform that action:

–Closing the lid.

–Pressing the power button.

Also, the computer goes into hibernation mode automatically in either of the following conditions:

•If a “hibernation time” has been set on the timer, and if the user does not do any operation with the keyboard, the hard disk drive, the parallel connector, or the diskette drive within that time.

•If the timer conditions are satisfied in suspend mode.

When the power is turned on, the computer returns from hibernation mode and resumes operation. The hibernation file in the boot record on the hard disk drive is read, and system status is restored from the hard disk drive.

23