Safety information
Electrical safety
Observe the following rules when working on electrical equipments.
Important:
Use only approved tools and test equipments. Some hand tools have handles covered with a soft material that does not insulate you when working with live electrical currents.
Many customers have rubber floor mats near their machines that contain small conductive fibers to decrease electrostatic discharges. Do not use such kind of mat to protect yourself from electrical shock.
•• Find the room emergency
•• Do not work alone under hazardous conditions or near the equipment that has hazardous voltages.
•• Disconnect all power before:
–Performing a mechanical inspection
–Working near power supplies
–Removing or installing main units
•• Before you start to work on the machine, unplug the power cord. If you cannot unplug it, ask the customer to
•• If you need to work on a machine that has exposed electrical circuits, observe the following precautions:
–Ensure that another person, familiar with the
Attention: Another person must be there to switch off the power, if necessary.
–Use only one hand when working with
Attention: An electrical shock can occur only when there is a complete circuit. By observing the above rule, you may prevent a current from passing through your body.
–When using testers, set the controls correctly and use the approved probe leads and accessories for that tester.
–Stand on suitable rubber mats (obtained locally, if necessary) to insulate you from grounds such as metal floor strips and machine frames.
Observe the special safety precautions when you work with very high voltages; instructions for these precautions are in the safety sections of maintenance information. Be extremely careful when you measure the high voltages.
•• Regularly inspect and maintain your electrical hand tools for safe operational condition.
•• Do not use worn or broken tools and testers.
•• Never assume that power has been disconnected from a circuit. First, check it to make sure that it has been powered off.
3
