CLEANING AND MAINTENANCE
1.Keep the phone away from bathtub, water or very high heat and humidity (keep away from stove or radiators).
2.Avoid placing it in very hot sun.
3.Do not staple phone cord.
4.Do not, under any circumstances, disassemble the telephone without disconnecting the cord from the telephone line first. Ringer voltages can be high and dangerous.
5.Cleaning the exterior surface of the set should be done on a regular basis. Use a cloth slightly dampened with warm, clean water to remove excess dust and dirt. Do not use benzine, thinner, or the like, or any abrasive powder to clean the cabinet. Wipe it with a soft cloth. The set should be kept free of dust, moisture and vibration, and should not be exposed to direct sunlight.
6.DO NOT USE WAXES, SOLVENTS OR DETERGENTS OF ANY KIND TO CLEAN YOUR UNIT. These products can damage the surface of the phone. Do not allow any liquids to get inside the case.
TROUBLE SHOOTING
PROBLEM | LIKELY CAUSES | ||
No dial tone | 1. Plug disconnected from jack. | ||
2. Jack improperly wired. | |||
| |||
|
|
| |
Phone is dead | 1. Damaged cord. |
| |
2. Jack improperly wired. | |||
| 3. Line out of order. |
| |
|
| ||
Can make calls but phone | 1. Ringer Switch in OFF position. | ||
does not ring | Slide the Switch to ON position. | ||
|
| ||
| 1. If your other telephones are “Rotary” type | ||
Can receive but cannot make | phones, your line may | be conditioned to | |
accept “Pulse” dialing only. | |||
calls | |||
Move Tone/Pulse Switch to “Pulse” position. | |||
| |||
| 2. Contact your phone company to have | ||
| your line changed to Tone and Pulse | ||
| service. |
| |
|
|
| |
Static noise on line or cannot hear | Replace the coil cord. | Any phone store has | |
calling party or calling party | these cords in different lengths. | ||
cannot hear you |
|
| |
1.If problems with your telephone service occur later, try to determine if the trouble is with the telephone or with the telephone comany equipment. Unplug the telephone and try it on another jack in a different room or in a neighbour’s home to see if the phone line is bad or the phone.
2.If disconnection of your equipment ends the problem, your telephone may be the source of the trouble and it should be tested and repaired if necessary before it is reconnected.
3.There are no user maintainable parts or adjustments on this set. Should your phone require repair, contact the factory for instructions (except for cords which you can buy at any phone store).
11 |
| |
|
E
