100Base-FX Module Installation

The installation procedure for each module is the same. Additional information about each module is provided below.

To install any of the modules: (Includes SC or ST type connectors)

1.Locate the module slot in the switch’s rear panel.

2.Using a screwdriver, undo the two screws and remove the dust cover on the module slot.

3.Holding the module component-side up and connector- side in, gently slide the module along the guides and seat it in the internal connector.

4.Using a screwdriver, replace the two screws and tighten until snug.

10

Page 13 Page 15
Page 14
Image 14
LevelOne FSW-2409TFX, FSW-1609TFX user manual 100Base-FX Module Installation
Page 13 Page 15
Top Page Image Contents