LevelOne FSW-1621, FSW-2421 user manual Desktop Installation, Rack-mounted Installation

Desktop Installation

Attaching Rubber Feet

A.Make sure mounting surface on the bottom of the Switch is grease and dust free.

B.Remove adhesive backing from your Rubber Feet.

C.Apply the Rubber Feet to each corner on the bottom of the Switch. These footpads can prevent the Switch from shock/vibration.

Rack-mounted Installation

FSW-1621/2421 10/100Base-TX Switch comes with a long rack-mounted kit and can be mounted in an EIA standard size, 19-inch Rack. The Switch can be placed in a wiring closet with other equipment.

Perform the following steps to rack mount the switch:

A.Position one bracket to align with the holes on one side of the switch and secure it with the smaller bracket screws. Then attach the remaining bracket to the other side of the Switch.

B.After attached both mounting brackets, position FSW-1621/2421 in the rack by lining up the holes in the brackets with the appropriate holes on the rack. Secure the Switch to the rack with a screwdriver and the rack-mounting screws.

Power On

Connect the power cord to the power socket on the rear panel of the Switch. The other side of power cord connects to the power outlet. The external power supply in the Switch works with AC in the voltage range 100-240VAC, frequency 50~60Hz.Check the power indicator on the front panel to see if power is properly supplied.