KVM-0850/1650 IP KVM switch
1. The Quick Installation Guide
Installation
KVM-0850/1650, 8-port/16-port PS/2 IP-KVM switch redirects local keyboard, mouse and video data
to a remote administration console. All data is transmitted via IP. KVM-0850/1650 can be used in a
multi administrator and multi server environment as well. Besides, KVM-0850/1650 is a KVM switch,
which can also be used with a local console. Connecting KVM-0850/1650 to the host system
In order to connect the KVM-0850/1650 perform the following steps:
1. Connect the power supply to KVM-0850/1650.
2. Connect the monitor to the KVM-0850/1650.
3. Connect the keyboard to the KVM-0850/1650.
4. Connect the mouse to the KVM-0850/1650.
5. Plug the HDDB15 pin connector of a 3-in-one cable into any label computer port on the rear of
KVM-0850/1650 unit. Then connect the HDDB-15 pin male type for PC video, the purple Mini Din
6 pin female type for keyboard and the green Mini Din 6 pin female type for mouse. To plug these
three connectors into the respective ports of computer.
6. Repeat item 5 procedure to all of PC ports of KVM-0850/1650
7. Connect Ethernet and/or modem, depending how you want to access KVM-0850/1650.
Video modes
KVM-0850/1650 recognizes a limited number of common video modes. When running X-Window on
the host system, please don’t use any custom mode lines with special video modes. If done so,
KVM-0850/1650 may not be able to detect these. You are on the safe side with all standard VESA
video modes. Please refer to Appendix C for a list of all known modes.
Initial IP configuration
Initially the KVM-0850/1650 network interface is configured with the parameters shown in Table 1.1.
Parameter Value
IP auto configuration DHCP
IP-Address 192.168.1.22
Net-mask 255.255.255.0
Default-Gateway none
IP access control disabled
Table 1.1: Initial configuration
If this initial configuration doesn’t meet your local requirements, you need to do the initial IP
configuration. Use one of the following ways:
1.Connect the enclosed NULL modem cable to the serial interface on the rear side. The serial
interface needs to be adjusted with the parameters shown in table 1.2:
Parameter Value
Bits/second 115200
Data bits 8
Parity No
Stop bits 1
Flow Control None
Table 1.2: Serial parameters
4