LG Electronics 26CS460T EYE-Q function check, 4.3. 3D function test, IR emitter inspection

4.2.EYE-Q function check

(1)Turn on TV.

(2)Press EYE key of Adjustment remote control.

(3)Cover the Eye Q II sensor on the front of the using your hand and wait for 6 seconds.

(4)Confirm that R/G/B value is lower than 10 of the "Raw Data (Sensor data, Back light)". If after 6 seconds, R/G/B value is not lower than 10, replace Eye Q II sensor.

(5)Remove your hand from the Eye Q II sensor and wait for 6 seconds.

(6)Confirm that "ok" pop up. If change is not seen, replace Eye Q II sensor.

4.3. 3D function test

(Pattern Generator MSHG-600, MSPG-6100[Support HDMI1.4]) * HDMI mode NO. 872 , pattern No.83

(1)Please input 3D test pattern like below. (HDMI mode No. 872 , pattern No.83)

(2)When 3D OSD appear automatically , then select OK key.

(3) Don't wear a 3D Glasses, Check the picture like below.

4.4.IR emitter inspection

(1)Start 3D pattern inspection.

(2)If IR emitter signal is correctly received to IR receiver, the lamp of IR tester turn on.

4.5. Outgoing condition Configuration

■When pressing IN-STOP key by SVC remocon, Red LED are blinked alternatively. And then automatically turn off. (Must not AC power OFF during blinking)

Copyright ©	LG Electronics. Inc. All rights reserved.	- 13 -	LGE Internal Use Only
Only for training and service purposes