LG Electronics 29FS2AMB/ANX Deflection setting initial data, OPTION setting, Preliminary steps

11. Deflection setting initial data

ITEM	Range	RF PAL			RF NTSC
					1080i/50
		100Hz	1080i/50
VL	0 ~ FFFF	FFFC	FFF3		FFDD
VA	0 ~ FFFF	004E	0014		002A
SC	0 ~ FFFF	009E	009E		007C
VS	0 ~ FFFF	FFF8	FF10	0003
HS	0 ~ FFFF	005D	005E		005C
EW	0 ~ FFFF	0044	0041		006C
ET	0 ~ FFFF	FFFB	FFDE		FFC0
EP	0 ~ FFFF	FFD0	FEE2		FE94
CRNU	0 ~ FFFF	0004	0004		FFF6
CRNL	0 ~ FFFF	000B	0025		002A
BOW	0 ~ FFFF	000B	0007	0007
ANGLE	0 ~ FFFF	000A	0009	0009
CRNU6	0 ~ FFFF	0056	003A	0056
CRNL6	0 ~ FFFF	003F	0030	0042

*Check adjustment condition at 1080i/50Hz, NTSC60Hz after finishing adjustment in PAL100Hz, adjust defection adjustment at each Mode again.

*Sequence

:PAL 100Hz(RF) -> NTSC 60Hz(RF) -> 1080i/50Hz(COMPONENT)

12.How to inspect condition of a transmission and reception in wireless sound model(option)

-Wireless sound model’s efficiency inspections is executed to a finished in a final inspection phase.

-Wireless sound is a function which receives voice-signal by an exclusive remote control and Earphone, transmits a FM through transmitter of inner part in MICOM BOARD to TV sound(MONITOR OUTPUT)

1)Execute in channel generating voice-signal

2)Select a transmitted frequency in MENU OSD.

3)A received frequency in an exclusive remote control or received FM Radio is tuned by 87.7MHz which is same as frequency in OSD.

4)Check out whether a signal generating to MAIN SPEAKER generates in earphone or receiver or not.

5)There is no alternation and setting of adjusted DATA in the process of inspecting FM TX.

13. OPTION setting

13-2. Preliminary steps

1)This option adjustment decides function in accordance with model. Press the SVC TX adjustment button(CH up/down button) at SVC mode, then adjust the option at OPTION1, 2, 3, 4, 5 mode.

2)Mark the option adjustment data like [111,111,111,111,111] in BOM.

OP [113,63,112,201,248]

OPTION 1

OPTION 2

OPTION 3

OPTION 4

OPTION 5

* Mark of BOM
LEVEL	PART NO.	SPECIFICATION	DESCRIPTION
1.	3141VMNxxxA	MAIN CHASSIS ASSY	OPT[091,016,143,100,000]

In this model, the OPTION1 data is 091, OPTION2 data is 016, the OPTION3 data is 143,the OPTION 4 data is 100, OPTION 5 data is 000.

13-2. Adjustment Method

1)Input OPTION value with number button on remote control at each OPTION adjustment mode.

2)At each OPTION Mode, Select adjustment item by the CH D, E button and then set up each OPTION by the F, G button.

- 13 -