LG Electronics 37LD340H Cloning Overview / Clonable Menu Features, Before you begin cloning

Cloning Overview / Clonable Menu Features

IMPORTANT CLONING INFORMATION

There are three options for cloning a Master TV Setup:

•Using a USB memory device

•Using a TLL-1100A clone programmer

•Using a LT2002 clone programmer

Each option is described in further detail on the pages that follow. As you perform cloning procedures, be sure to com- plete each task as indicated. If a procedure or step is omit- ted or not performed completely, cloning may not work. At each step, pay attention to ensure the TV screen shows the proper message when cloning. If the message indicat- ed does not appear, there is a problem with that step, and cloning may not be successful.

Warning: Copying a blank or incorrect memory into a TV will cause the TV to operate erratically or become inoperable.

Warning: Do not connect a clone programmer to a PPV card installed in the Master or Target TVs. Also, if the TV is in LodgeNet PPV Mode (check with the site administrator if you are not cer- tain), do not connect a clone programmer to the GAME CONTROL/MPI port. Either of these actions will damage the clone programmer and, if applicable, the PPV card.

Before you begin cloning:

•Complete the Commercial Mode Setup procedure on pages 12 to 13.

•All equipment should be connected to power and turned ON.

•Learning and Teaching is only possible between identical model TVs.

•For both Master and Target TVs—The TV EBL must be in Pass-through Mode.

•If using a USB memory device, ensure the USB device has been formatted with FAT format.

•For both Master and Target TVs—If using a clone pro- grammer, ensure the TV signal source is either an Aux or TV (RF) source. If a TV (RF) source, the TV must be tuned to an analog (not a digital) channel.

•LT2002 only—Make sure the batteries in the clone pro- grammer are fresh. If batteries are removed, the clone programmer clock time (if set) will be lost (see page 32 for information on the clone programmer clock).

•Do not unplug the TV power cord or remove/disconnect the USB memory device/clone programmer while Learning or Teaching, as doing so may cause the TV to malfunction or harm the USB device/clone programmer, respectively.

Clonable Menu Features

Installer Menu	Audio	Lock
Installer Menu item settings	Auto Volume	Movie Rating
	Clear Voice	TV Rating – Children
Channel	Sound Mode	TV Rating – General
Auto Tuning (Channel Lineup)	Balance	Input Block
Manual Tuning	TV Speaker	Time
Channel Edit
Channel Label	Option	Auto Clock
	Menu Language	Manual Clock
Picture	Audio Language	Off Time
Aspect Ratio	Caption	On Time
Picture Mode	Caption Mode	Auto Off (Sleep Timer)
Advanced Control	Digital Caption Options

Note: Some menu options vary between analog and digital channels and Aux sources.

206-4163 27