LG Electronics 3828ER3020V Washer/Combo Installation, Excessive Weight Hazard

IMPORTANT: Read and follow these instructions.

NOTICE	The installer must have electrical and mechanical training and acceptable knowledge in the
	required work.

Safety is foremost---both your own and that of other people. Many important safety instructions are provided in this instruction and your appliance. Always read and observe all safety instructions.

WARNING

Excessive Weight Hazard

Two or more people may be needed to install and move the appliance and pedestal assembly.

Do not allow children to play on the drawer. Do not step on the handle.

WASHER/COMBO INSTALLATION

1 Remove pedestal, installation hardware, and instructions from the shipping carton.

2 Position the washer/combo on top of the pedestal. NOTE: Because of the weight of the

washer/combo, two or more people may be needed.

NOTE: If the washer or combo was previously installed, unplug it, disconnect the inlet hose (s) from the faucet (s), disconnect the drain hose, and drain all hoses.

for washer/

combo for dryer

for dryer

for washer/ combo

4 Remove the paper from the bracket.

5 Attach the double-faced tape of the bracket to the

Level the washer/combo on the pedestal by

3 washer/combo as shown so the bent parts of the adjusting the feet.

brackets align with the edge and can be attached to the pedestal with screws.

NOTE: Attach the lower side first.

	Lock
	nut
	Adjustable
	feet
Be sure to press the adhesive parts of the brackets
Higher	Lower
6 firmly to the appliance.
Adjustable	Adjustable
feet	feet

4 Remove the paper from the bracket.

7 Install the eight (8) screws (supplied) to attach the brackets to the pedestal.

5 Attach the double-faced tape of the bracket to the washer/combo as shown so the bent parts of the brackets align with the edge and can be attached to the pedestal with screws. NOTE: Attach the lower side first.

8 Move the washer/combo to the desired place. NOTE: The applianceand pedestal assembly

must be placed on a solid and level floor for proper operation. Adjust the legs of the appliance and pedestal by turning with a wrench. Then, adjust the lock nut toward the pedestal while holding the pedestal leg using a wrench.

2