APPENDIX
110

EXTERNAL CONTROL THROUGH RS-232C

APPENDIX

RS-232C Setup

The RS-232C port allows you connect the RS-232C input jack to an external control device (such as a computer
or an A/V control system) to control the TV’s functions externally.
■Note: RS-232C on this unit is intended to be used with third party RS-232C control hardware and software.
The instructions below are provided to help with programming software or to test functionality using telenet
software.
AUDIO IN
(RGB/DVI)
ANTENNA/
CABLE IN
AUDIO
RGB IN (PC)
REMOTE
CONTROL IN
O AUDIO
L(MONO)
R
L
SPEAKER OUT
R
L R
AV IN 1
2
1
/DVI IN
OPTICAL DIGITAL
AUDIO OUT
RS-232C IN
(
CONTROL&SERVICE)

Type of Connector; D-Sub 9-Pin Male

No. Pin Name
1 No connection
2 RXD (Receive data)
3 TXD (Transmit data)
4 DTR (DTE side ready)
5 GND
6 DSR (DCE side ready)
7 RTS (Ready to send)
8 CTS (Clear to send)
9 No Connection
1
6
5
9
PC

Communication Parameters

■Baud rate : 9600 bps (UART)
■Data length : 8 bits
■Parity : None
■Stop bit : 1 bit
■Communication code : ASCII code
■Use a crossed (reverse) cable.

NOTE

!
GGThis product has command echo back in the
RS-232C Command.