Express Script Installer Menu Wizard (Cont.)

(Continued from previous page)

2.In the Pro:Centric Mode field, use the Left/Right arrow keys on the Installer Remote to select the appropriate Pro:Centric Application Mode—GEM, FLASH, or Configuration Only.

3.Once the fields are completed as required, you have two options:

•To proceed with TV configuration via the wizard, select Next and press OK on the Installer Remote. See also “Complete the TV Configuration” below.

•To save the data entered and exit the wizard, select Done and press OK on the Installer Remote. Remember, however, that if you bypass the Express Script, pillow speaker functionality will not be enabled unless you set Installer Menu item 027 HOSPITAL MODE appropriately. See the “Installer Menu” section of this document for further information.

Note: If you intend to use a TLX file for cloning or FTG Mode configuration purposes, exit the Express Script at this time.

Complete the TV Configuration

The following procedure describes the remaining Express Script Installer Menu Wizard steps. You can select the “Back” button, where available, to check previous settings, as necessary.

Note: If you choose to exit the Express Script from this point on, any settings made will not be retained.

1.Select the tuning band.

Use the Up/Down arrow keys on the Installer Remote to select the tuning band field, and then use the Left/Right arrow keys to select the appropriate tuning band: Cable Standard (default), Cable HRC, Cable IRC, or Air. When you have made your selection, use the arrow keys to select Next, and then press OK.

2.Select the Aux inputs.

If you simply select Next and press OK in this step, default values will be used, i.e., all Aux inputs will be enabled. Otherwise, use the Up/Down arrow keys on the Installer Remote to select the desired Aux input option(s).

Note: If an Aux input will not be used, it is advisable to disable it. After the TV setup is transferred to the PTC (see step 8), the only way to remove Aux inputs from the channel lineup, is to go to the Channel Preview/Banks Setup Menu and select Normal-Deleted.

•To customize settings, select Customize Inputs and press OK. Aux input options are displayed in a pop-up window. Use the arrow keys to select the input(s) to enable or disable. When you are finished, press OK on the Installer Remote. Then, continue with step 3.

Note: If you would like to return to the Aux Input screen, press MENU to close the pop-up window.

•To use default values, select Use Default Values and press OK. Then, continue with step 3.

Installer Menu Wizard

1 ► 2 ► 3 ► 4 ► 5 ► 6 ► 7 ► 8

Step 1. Tuning Band

Which tuning band would you like to use?

Cable Standard

BackNext

PTC: V1.00.020 CPU: V03.11.00.01 ASIC: D279

OK CC

Exit

Note: Typically, if you do not modify the default settings, the “Next” option is automatically selected when you proceed forward within the wizard. Where appropriate, you can simply press OK on the Installer Remote to proceed to the next step

if the default value(s) for the TV parameter(s) in question are applicable for your installation.

Installer Menu Wizard

1 ► 2 ► 3 ► 4 ► 5 ► 6 ► 7 ► 8

Step 2. Aux Input

Which inputs will you be using?

Customize Inputs

Use Default Values

BackNext

PTC: V1.00.020 CPU: V03.11.00.01 ASIC: D279

OK CC

Exit

(Continued on next page)

14

206-4261