LG Electronics 50PX4D, 50PX5D, 50PX4D-UB, 50PX5D-UB Channel Add/Del Command m b, Key Command m c

External Control Device Setup

*All data are transmitted by Hexadecimal code *Two/One part Channel: 6th bit

This bit is used in a cable-ready system. *Using physical channel: 5th bit

If the channel band is NTSC air or NTSC cable, channel tun- ing can be done by only physical channel. In this case, using physical channel bit must be low(0).

But if the channel band is ATSC air or ATSC cable, there are two cases that physical channel enable or disable.

If the physical channel sending is meaningful, you should set this bit low(0). If the physical channel sending is meaningless, you should set this bit high(1).

Example)

1. Analog channel: NTSC cable, channel number(35), main

picture Command: ma 00 23 xx xx xx xx 01 attribute(0x01): main picture, two part(it’s not mandatory), using physical chan- nel, NTSC cable ‘xx’ data: don’t care major and minor channel number in case analog channel tuning.

2. Digital channel: ATSC air, channel number(don’t know phys- ical channel, major(30), minor(3)), sub picture

Command: ma 00 xx 00 1E 00 03 A2 attribute(0xA2): sub pic- ture, two part, not using physical channel, ATSC air ‘xx’ data: don’t care analog channel number in case digital channel tun- ing.

3. Digital channel: ATSC air, channel number(physical(20),major(20), minor(3)), sub picture Command: ma 00 14 00 14 00 03 82 attribute(0x82): sub pic- ture, two part, using physical channel, ATSC air.

Acknowledgement

[a][ ][Set ID][ ][OK][Data0][Data1][Data2][Data3][Data4][Data5][x] [a][ ][Set ID][ ][NG][Data0][x]

26. Channel Add/Del (Command: m b)

G To add and delete the channels

Transmission

[m][b][ ][Set ID][ ][Data][Cr]

Data 0: Channel Delete

1:Channel Add

Acknowledgement

[b][ ][Set ID][ ][OK][Data][x] [b][ ][Set ID][ ][NG][Data][x]

27. Key (Command: m c)

G To send IR remote key code

Transmission

[m][c][ ][Set ID][ ][Data][ ][Cr]

Data Key code: Refer to page 99.

Acknowledgement

[c][ ][Set ID][ ][OK][Data][x]

28. Input select(Command: x b) (Main Picture Input)

G To select input source for TV.

Transmission

[x][b][][Set ID][][Data][Cr]

Data Structure

	DATA(Hex)		INPUT
00		DTV (Antenna)
01		DTV (Cable)
10		Analog (Antenna)
11		Analog (Cable)
20		Video
21		Front Video
40		Component 1
41		Component 2
50		RGB DTV
60		RGB PC
90		HDMI1/DVI
91		HDMI2

Acknowledgement

[b][ ][Set ID][ ][OK/NG][Data][x]

29. PIP Input Select(Command: x y)

GTo adjust input source for sub picture in PIP mode Transmission

[x][y][][Set ID][][Data][Cr]

Data Structure

	DATA(Hex)		INPUT
00		DTV (Antenna)
01		DTV (Cable)
10		Analog (Antenna)
11		Analog (Cable)
20		Video
21		Front Video

Acknowledgement

[y][][Set ID][][OK/NG][Data][x]

Owner’s Manual 97