43
206-4213
FTG Mode via CPU (Cont.)
Typical Installer Menu
Note: The Installer Menu header will vary
depending on the TV you are setting up.
Use Channel Menu options to run
Auto Tuning and edit the channel
lineup, as necessary.
Adjust the values for these
Installer Menu items.
117 FACT DEFAULT 000
003 BAND/AFC 001
Set Installer Menu Items
These steps provide specic instruction only on the Installer Menu items
that should be set on an LT670H or LS675H TV. Refer to pages 18 to 26 for
detailed information on all Installer Menu items.
1. Turn ON the TV.* Then, use the Installer Remote to access the Installer
Menu (see “Accessing the Installer Menu” on page 18 for further infor-
mation).
2. Set Installer Menu item 117 FACT DEFAULT to 001 and press OK on
the Installer Remote.
This clears all Installer Menu custom settings, the channel lineup, etc.
and restores the factory default settings. The value will change back
to 0 after the commercial controller (PTC) has been restored to factory
default condition. This step ensures that the TV Channel Memory will be
the active channel lineup.
3. Set Installer Menu item 003 BAND/AFC, as appropriate.
• Broadcast: Set to 000. • HRC: Set to 002.
• CATV: Set to 001 (default). • IRC: Set to 003.
4. Set any other Installer Menu items that affect your TV programming
network to the required conguration. For example, enable/disable Aux
inputs, set a Start Channel, etc.
5. After you have adjusted all Installer Menu item settings as required, press
OK once on the Installer Remote to save your changes; then, press OK
again to exit the menu.
Run Auto Tuning (Channel Search)
Note: In the FTG Conguration le, Logical Channel numbers will automati-
cally be assigned in ascending order, starting with 0 (zero), to the Physical
Channels from the TV Channel Map.
Note: Pro:Idiom decryption for encrypted channels will not be enabled unless
you use the FTG File Manager to set the channel attributes.
1. Search for all available analog and digital channels: Use the Installer
Remote to go to the Channel Menu, select the Auto Tuning option, and
follow the on-screen instructions.
2. Use the Channel Edit option in the Channel Menu to edit the channel
lineup, as necessary, to include free to guest channels only. Add/delete
channels per your system requirements.
Optional Manual Conguration / TV Setup
The manual configuration procedures below should only be performed if you do not know the RF channels
at the site and need to “Learn” FTG Configuration from an LT670H or LS675H TV as described on the
previous page. Ensure the TV is in Pass-through Mode before you begin.
Once you have completed these procedures, return to “Learning FTG
Conguration from a TV” on the previous page to complete the Learn sequence.
xxLT670H PTC INSTALLER MENU
CPU-CTV
000 INSTALLER SEQ 000
UPN 000-000-000-000 ASIC D279
PTC V1.00.009 CPU V3.17.00

CHANNEL

OK
Move
• Auto Tuning
Manual Tuning
Channel Edit
Channel Label
* If the Automated Installation Routine Wizard appears on the screen when you turn ON the TV, use the Up/Down arrow
keys on the Installer Remote to select Exit from the Welcome screen, and press OK to exit the wizard. Note that in this
case, you will not need to perform step 2 because the TV is already in a factory default state.