LG Electronics 5CSV2-03A manual VK/VL Chassis Models, Installation of Unit

15. Installation

VK/VL Chassis Models

■Installation of Unit

Unit should be installed for horizontal and vertical dis- charge application only.

CASE 1

POSITION OF SUSPENSION BOLT

•Apply a joint-canvas between the unit and duct to absorb unnecessary vibration.

			(Unit:mm)
Dimension	A	B	C
Model
36k	1350	1255	220
48k, 60k	1750	1655	220

CASE 2

•Install the unit leaning to a drainage hole side as a fig- ure for easy water drainage.

160

320

50 B 50

C

A

320 160

	650
Suspension
bolts
Spring
washer	Nut
Max.	Washer
12mm

POSITION OF CONSOLE BOLT

•A place where the unit will be leveled and that can support the weight of the unit.

•A place where the unit can withstand its vibration.

•A place where service can be easily performed.

•Select and mark the position for fixing bolts.

•Drill the hole for set anchor on the face of ceiling.

•Insert the set anchor and washer onto the suspension bolts for locking the suspension bolts on the ceiling.

•Mount the suspension bolts to the set anchor firmly.

•Secure the installation plates onto the suspension bolts (adjust level roughly) using nuts, washers and spring washers.

:Tighten the nut and bolt to prevent unit falling

Old building New building

1 Set anchor

2 Plate washer

3 Spring washer

4Nut

5Suspension bolts

•Local supply

Set anchor
Plate washer	- M10
Spring washer	- M10
Nut	- W3/8 or M10
Suspension bolt	- W3/8 or M10

70Ceiling & Floor, Ceiling Suspended (50Hz, R22)