Magic Remote Functions
(Image shown may differ from your TV.)
When the message Magic remote battery is low. Change the battery. is displayed, replace the battery. To install batteries, open the battery cover, replace batteries (1.5 V AA) matching 
and 
ends to the label inside the compartment, and close the battery cover. Failure to match the correct polarities of the battery may cause the battery to burst or leak, resulting in fire, personal injury, or ambient pollution. Be sure to point the remote control at the remote control sensor on the TV.
To remove the batteries, perform the installation actions in reverse.
This remote uses infrared light. When in use, it should be pointed in the direction of the TV’s remote sensor.
CAUTION
••Do not mix old and new batteries, as this may damage the remote control.
A
A
(POWER) Turns the TV on or off. 
(Input) Changes the input source.
Number button Enters numbers.
-(Dash) Inserts a dash between numbers such as
LIST Accesses the saved channel list.
INFO Shows information on the current program.
B
C
B
VOL Adjusts the volume level. |
| |
(MUTE) Mutes all sounds. | ENGLISH | |
••By pressing and holding the button, VD | ||
| ||
function will be enabled. |
| |
••SAP (Secondary Audio Program) Feature can |
| |
also be enabled by pressing the key. |
|
(Home) Accesses the Home menu.
CH
Scrolls through the saved channels.
(Back) Returns to the previous screen.
EXIT Clears all
C
(up/down/left/right) Press the up, down, left or right button to scroll the menu. If you press 
buttons while the pointer is in use, the pointer will disappear from the screen and Magic Remote will operate like a general remote control. To display the pointer on the screen again, shake Magic Remote to the left and right.
Wheel (OK) Press the center of the Wheel button to select a menu. You can change channels by using the Wheel button.
(Q. Settings) Accesses the quick settings.
13
