LG Electronics D5966W Routing and Connecting Ductwork, Correct Venting, Incorrect Venting

I N S TA L L AT I O N I N S T R U C T I O N S

VENTING THE DRYER (cont.)

Ductwork
		Number of	Max. Length of 4-In. Dia.	Max. Length of 4-In. Dia.
Wall Cap Type		90° Elbows	Rigid Metal Duct	Flexible Metal Duct
Recommended		0	65 ft. (19.8 m)	45 ft. (13.7 m)
		1	55 ft. (16.8 m)	35 ft. (10.7 m)
		2	47 ft. (13.7 m)	30 ft. (9.1 m)
		3	36 ft. (11.0 m)	25 ft. (7.6 m)
4"	4"	4	28 ft. (8.5 m)	20 ft. (6.1 m)
(10.2 cm)	(10.2 cm)
Use Only for Short		0	55 ft. (16.8 m)	35 ft. (10.7 m)
Run Installations		1	47 ft. (13.7 m)	27 ft. (8.1 m)
		2	41 ft. (12.5 m)	21 ft. (6.4 m)
21/2"		3	30 ft. (9.1 m)	17 ft. (5.2 m)
(6.35 cm)		4	22 ft. (6.7 m)	15 ft. (4.5 m)

NOTE: Deduct 6 ft. (1.8 m) for each additional elbow. It is not recommended to use more than four 90° elbows.

Routing and Connecting Ductwork

Follow the guidelines below to maximize drying performance and reduce lint buildup and condensation in the ductwork.

NOTE: Ductwork and fittings are NOT included and must be purchased separately.

•Use 4-in. (10 cm) diameter rigid or semirigid metal ductwork.

•The exhaust duct run should be as short as possible.

•Use as few elbow joints as possible.

•The male end of each section of exhaust duct must point away from the dryer.

•Use duct tape on all duct joints.

•Insulate ductwork that runs through unheated areas in order to reduce condensation and lint buildup on duct surfaces.

IMPORTANT: Failure to exhaust the dryer correctly will void the dryer's warranty.

Correct Venting

Incorrect Venting

15