LG Electronics DNX190MH Setting up the Player, DVD Player Connections, Resolution setting

Installation and Setup

Setting up the Player

The picture and sound of a nearby TV, VCR, or radio may be distorted during playback. If this occurs, position the player away from the TV, VCR, or radio, or turn off the unit after removing the disc.

DVD Player Connections

Depending on your TV and other equipment there are various ways you can connect the player. Please refer to the manuals of your TV, stereo system or other devices as necessary for additional connection information.

SCART INPUT

Do not connect the DVD Player’s AUDIO OUT jack to the phone in jack (record deck) of your audio system.

Component Video – Connect the COMPONENT VIDEO OUT/ (576p/720p) jacks on the DVD Player to the corresponding in jacks on the TV using an Y Pb Pr cable (C).

Progressive Scan

•If your television is a high-definition or “digital ready” television, you may take advantage of the unit’s progressive scan output for the highest video resolution possible.

•Progressive scan does not work with the analog video connections

(yellow VIDEO OUT jack).

•The 720p and 576p(480p) resolutions are the progressive scan applied resolution.

Introduction

and Setup

T

Caution:

You must set the TV Output Select option on the setup menu to use COMPONENT VIDEO OUT/ (576p/720p) jack or SCART’s RGB signal. (Refer to page 13.)

Video and Audio Connections to Your TV

Make sure the DVD player is connected directly to the TV and not to a VCR, otherwise the DVD image could be distorted by the copy protection system.

SCART connection – Connect the TO TV scart jack on the DVD player to the corresponding in jacks on the TV using the scart cable (T).

Video – Connect the VIDEO OUT jack on the DVD player to the video in jack on the TV using the video cable (V)

Audio – Connect the left and right AUDIO OUT jacks of the DVD Player to the audio left and right IN jacks on the TV (A) using the audio cables.

Resolution setting

1.Before you set the resolution, this unit must be in stop mode. Press STOP to stop playback.

2.Press RESOLUTION once. The current resolution setting will be appears in the display window.

3.Press RESOLUTION repeatedly to change the resolution you want.

The available resolution according to the connections are as shown below.

OUTPUT	Available Resolution
CONNECTION	PAL	NTSC
HDMI	1920 x 1080i	1920 x 1080i
	1280 x 720p	1280 x 720p
VIDEO OUT
	720 x 576p	720 x 480p
COMPONENT	1280 x 720p	1920 x 1080i
		1280 x 720p
	720 x 576p
VIDEO OUT		720 x 480p
	720 x 576i
		720 x 480i
VIDEO OUT	720 x 576i	720 x 480i
SCART	720 x 576i	720 x 480i

Notes:

•For Video and SCART connections, resolution must be set to 576i(480i) or 576p(480p) by pressing RESOLUTION button, however Video OUT and SCART is always at 576i(480i) standard resolution.

•If your TV does not accept your resolution setting, abnormal picture appears on the screen.

Please read TV’s owner’s manual then set the resolution that your TV can accept.

•For 720p and 1080i resolution on the component video out, only non-copy protected discs can be played back. If the disc is copy protected, it will be displayed at the 576p(480p) resolution without HDMI cable connection. With HDMI cable connection, the picture may not be displayed properly.

Installation

Operation

Reference

9