Installation and Setup
TV Connection
Make one of the following connections, depending on the capabilities of your existing equipment.
Tip:
•Depending on your TV and other equipment you wish to connect, there are various ways you could connect the unit. Use one of the connections described below.
•Please refer to the manuals of your TV, VCR, Stereo System or other devices as necessary to make the best connections.
Caution:
•Make sure the unit is connected directly to the TV. Select the correct AV input on your TV.
•Do not connect your unit to the TV via your VCR. The DVD image could be distorted by the copy protection system.
Video connection
Connect the VIDEO OUT jack from the unit to the VIDEO IN jack on the TV using the video cable supplied (V).
Component Video connection
Connect the COMPONENT VIDEO OUT jacks from the unit to the corresponding jacks on the TV using a Y Pb Pr cable (C).
Rear of TV
Antenna (Aerial) Connections
Connect the supplied FM/AM antennas for listening to the radio.
Note:
•To prevent noise pickup, keep the AM loop antenna away from the unit and other components.
•Be sure to fully extend the FM wire antenna.
•After connecting the FM wire antenna, keep it as horizontal as possible.
FM wire antenna (supplied)
AM(MW) loop antenna (aerial) (supplied)
For AM(MW) reception,connect the loop antenna (aerial) to the terminal marked AM
| COMPONENT VIDEO / | VIDEO | |
PROGRESSIVE SCAN INPUT | INPUT | ||
Y | Pb | Pr | L |
|
|
| |
C 
V
8
