Troubleshooting 17
Troubleshooting
PROBLEM | CAUSE & CORRECTION | |
|
| |
| yy The power cord is unplugged. | |
No Power | Plug in the power cord. | |
yy Check the condition by operating other electronic devices. | ||
| ||
|
| |
| yy Incorrect input source is selected. | |
No sound | Check the input source and select the correct input source. | |
yy The mute function is activated. | ||
| ||
| Press ior adjust the volume level to cancel the mute function. | |
|
| |
| yy The remote control is too far from the unit. | |
| Operate the remote control within about 7 m. | |
The remote control | yy There is an obstacle in the path of the remote control and the unit. | |
does not work | ||
Remove the obstacle. | ||
properly. | ||
yy The battery in the remote control is exhausted. | ||
| ||
| Replace the battery with new one. | |
|
| |
The Auto power | yy Depending on the connected device, this function may not operate. | |
on/off function does | yy Check the status of AUTO POWER ON/OFF switch on the rear panel of the unit. | |
not work. |
| |
|
| |
| Check the details below and adjust the unit according to them. | |
When you feel the | yy With the unit connected with TV, change the AUDIO DIGITAL OUT setting on TV | |
Setup Menu from [PCM] to [AUTO] or [BITSTREAM]. | ||
output sound of the | yy With the unit connected with Player, change the AUDIO DIGITAL OUT setting on | |
unit is low. | ||
Player Setup Menu from [PCM] to [PRIMARY | ||
| ||
| yy Change Audio DRC setting on Player setup menu to [OFF] state. | |
|
| |
| Depending on the type of the furniture where the unit is placed, you might hear a | |
There is a noise on | slight noise from the furniture due to the dual subwoofers built within the product. | |
yy Check the supporting furniture whether it is sufficiently firm and horizontal. | ||
the periphery of the | ||
unit. | yy However, if you still hear a noise, place a tablecloth between the unit and the | |
| surface. | |
|
|
3
Troubleshooting
