LG Electronics LP7000R, LP6000ER owner manual Remote Control Operations, 425

Operating Instructions

Remote Control Operations

The remote control and control panel will look like those represented in the following pictures.

1 6 3

AIR

PURIFIER

Air

Purifier Power

Temp

Fan Speed

Timer Mode

5

Auto

Timer Swing

425

1

2

4

3

RemoteControl Operations

1POWER

•To turn the air conditioner ON, push this button. To turn the air conditioner OFF, push the button again.

•This button takes priority over any other button.

•When you first turn it on, the unit is in cool mode, high fan speed, temperature setting at 72˚F.

2TEMPERATURE SETTING

•Use this button to automatically control the temperature of the room.

The temperature can be set within a range of 60°F to 86°F by increments of 1°F.

3MODE

-Every time you push this button, it will cycle through the following modes: COOL, ENERGY SAVER, FAN and DRY.

-ENERGY SAVER

•The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on and the unit will check the room air to determine if cooling is needed.

4FAN SPEED

•Every time you push this button, it advances the setting as follows: {High(F3) → Low(F1) → Med(F2) → High(F3)}

5TIMER

- SHUT-OFF TIME

•You will usually use shut-off time while you sleep.

•With unit running, use Timer to set number of hours until shut-off.

•For your sleeping comfort, once Time is set, the Temperature setting will raise 2°F after 30 min, and 2°F after another 30 min.

•Every time you push Timer button, it advances the Timer setting as follows: 1 Hour → 2 Hours → etc. → 12 Hours maximum.

- START TIME

•With unit not running, use timer to set number of hours before unit starts.

•Every time you push Timer button, it advances the Timer setting as follows: 1 Hour → 2 Hours → etc. → 12 Hours maximum.

6 REMOTE CONTROL SENSOR

AUTO RESTART

When power is restored after an electrical power failure, the unit will begin to run at its last setting.

6