Installation
Operation instruction guide
Connect the tubing to
the refrigerator
Turn the water on at the shutoff valve
Before making the connection to the refrigerator, be sure the refrigerator power cord is not plugged into the wall outlet.
1.Remove the plastic flexible cap from the water valve.
2.Place the compression nut and ferrule (sleeve) onto the end of the tubing as shown.
3.Insert the end of the copper tubing into the water valve connection as far as possible. While holding the tubing, tighten the fitting.
Tighten any connections that leak.
Copper tubing
(Provided) Compression nut
(Provided) 
Ferrule (sleeve) 
Water valve
Automatic ice maker
Plug In the Refrigerator
Arrange the coil of copper tubing so that it does not vibrate against the back of the refrigerator or against the wall. Push the refrigerator back to the wall.
Start the lcemaker
Set the ice making stop switch to the ON position The icemaker will not begin to operate until it reaches its operating temperature of 15 °F
The automatic ice maker can automatically make 8 pieces of ice cube at a time,
But these quantities may be varied according to various conditions including how many times the refrigerator door opens and closes.
Ice making stops when the ice storage bin is full.
NOTE
•It is nomal that a noise is produced when ice made is dropped into the ice storage bin.
10
